Items where Author is "Groš, Josip"

Up a level
Export as [feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
Group by: Item Type | No Grouping
Number of items: 6.

Thesis

Groš, Josip (2009) Utjecaj vakuuma na livljivost pri lijevanju u jednokratne pune kalupe. = Master's thesis (Bologna) , Sveučilište u Zagrebu, Fakultet strojarstva i brodogradnje, UNSPECIFIED. Mentor: Budić, Ivan.

Article

Medić, Srđan and Groš, Josip and Horvatić Novak, Amalija and Kondić, Živko and Maglić, Leon (2016) Measurement of casting parameters in ZnAlCu3 molds created by additive technology. = Measurement of casting parameters in ZnAlCu3 molds created by additive technology. Metalurgija, 55 (4). pp. 705-708. ISSN 0543-5846. Vrsta rada: ["eprint_fieldopt_article_type_article" not defined]. Kvartili JCR: Q2 (2016). Točan broj autora: 5.

Medić, Srđan and Runje, Biserka and Groš, Josip and Markučič, Damir (2013) Postupci primjene norme ISO/TS 29001:2010 u proizvodnim tvrtkama RH. = Procedures for the implementation of ISO/TS 29001:2010 in the Croatian manufacturing companies. Tehnički glasnik, 7 (3). pp. 306-310. ISSN 1864-6168. Vrsta rada: ["eprint_fieldopt_article_type_article" not defined]. . Točan broj autora: 4.

Conference or Workshop Item

Horvatić Novak, Amalija and Runje, Biserka and Novak, Igor and Groš, Josip and Medić, Srđan (2017) Use of different fitting methods in computed tomography dimensional measurements. = Use of different fitting methods in computed tomography dimensional measurements. In: 16th International Scientific Conference on Production Engineering, 8-10.06.2017., Zadar, Hrvatska.

Medić, Srđan and Runje, Biserka and Groš, Josip and Markučič, Damir (2013) Implementacija zahtjeva norme ISO/TS 29001:2010 u hrvatske proizvodne tvrtke. = Implementation of ISO/TS 29001:2010 requirements in Croatian production companies. In: 13.hrvatska konferencija o kvaliteti i 4.znanstveni skup hrvatskog društva za kvalitetu, 09–11.05.2013., Brijuni, Hrvatska.

Groš, Josip and Balder, Damir and Ciglar, Damir and Math, Miljenko (2011) A comparison between the main cutting force of a turning center and that obtained by deform 3D software. = A comparison between the main cutting force of a turning center and that obtained by deform 3D software. In: International Scientific Conference on Production Engineering (13 ; 2011), 16-18.06.2011., Biograd, Hrvatska.

This list was generated on Mon Sep 27 07:35:13 2021 CEST.